HOME
3 Axis System Kit -425
(1) XS-3525/8S-3 Stepper Motor Driver Board and IDC26-DB25 cable
(3) 425 oz.in. Nema 23 Mounting Double Stack/Double Shaft Bipolar Stepper Motor
Click on the link above to see if these motors are right for your project
(1) 24VDC/5.0A Power Supply with 120VAC Power Cord, and 24VDC Pigtail
(1) 2.3" X 2.3" X 1" 24VDC Fan with 2-pin Molex conenctor
Drive Setup Instructions
$310.00 plus USA Shipping Flat $15.00 via USPS Priority Mail(other countries e-mail for shipping cost)
What you will also need: Good Quality Parallel port extension cable (3 to 6 foot) 4 Conductor wire (22ga. min.) to go from stepper drive to motors A PC running G-code software such as Mach2 or TurboCNC Your CNC ready Mill/Router/etc. A ventilated case to put it all in (optional) The stepper motor drive board plays NO role in Home/Limit/STOP switch inputs, or various outputs, other than to provide screw point attachments to the parallel port I/O. See your software configuration setup for these types of I/O usages.
The stepper motor drive board plays NO role in Home/Limit/STOP switch inputs, or various outputs, other than to provide screw point attachments to the parallel port I/O. See your software configuration setup for these types of I/O usages.
USA Customers, Use Paypal Processing and get
Free USPS Priority Mail Shipping (2-3 Day transit time) (save $15.00)
Get the whole setup: Xylotex 3 Axis Drive, 24VDC/5.0A Power Supply & Fan and the (3) 425 oz.in. Motors in one place with NO Shipping charges
$310.00